See Static Parameters for more informations. Just right-click on him and set "Allow animation".
In the layer's parameters of the time loop, you need to remove the 'green guy' ( ), indicating that the parameter is "Static", from Duration Parameter. When the Time Loop layer is asked to set its time to "Local Time", it sets the time in its child layers to be "Link Time", ie. "Local Time" is used to line up the offset of the time looping. The "Time Loop layer" repeatedly loops through the "Duration" seconds of its child layers, from "Link Time" to "Link Time" + "Duration". This is to provide compatibility with version 0.1 of the time loop layer. If not checked, and the current time is less than "Local Time", then "Duration" is taken off the resulting time. If not checked and the Duration is zero, the Time Loop layer freezes the animation of the children layers at the value of "Link Time". If checked and "Duration" is zero or negative, then the time loop layer is effectively disabled, and acts as if it wasn't there. Number of seconds or frames that are looped in the child layer. Start time of cycled material/child layers. The parameters of the time loop layers are: These parameters, to prevent undesired modification, by default are statics. See also the Time Loop ValueNode conversion, which can be used to loop the value of a single parameter, rather than an entire layer or group of layers. It loops a section of the layers below and within the same canvas over and over. 
The "Time Loop layer" is used to repeat an animation over and over.
0 kommentar(er)
